1 models · Mobile fitting
Jannarelly battery replacement
Pick your model, send the year, and we confirm the right battery before we set off.
Jannarelly models
How we match a Jannarelly battery
- 01
Send the model, year and a photo of the battery label.
- 02
We match technology, size, terminals and ratings to your car.
- 03
We fit it where you park and check the charging system.
Updated 5 November 2026
Jannarelly Design-1 battery replacement in Dubai: care for a rare roadster
Jannarelly battery replacement is not something many people search for, because there are very few Jannarellys. The company is a small specialist car maker founded in Dubai, and its Design-1 is a lightweight, retro-styled roadster assembled at the company’s base here. The production car uses a Nissan V6 engine. Jannarelly has also shown concepts for an electric version, known as the Design-X1, but we have not seen confirmation that it reached series production.
If you own a Design-1, you already know it is not an ordinary car. The battery is a small part of it, but a flat one will stop a weekend drive as surely as anything else. Here is how to think about it.
What we know, and what we check
Public information about the Design-1’s battery is limited. There is no widely published specification for its size, capacity or type, and hand-built cars can vary from one example to the next. So rather than quote numbers, we work from the car itself:
- The label on the current battery. It usually shows the capacity (Ah), cold cranking amps (CCA), size code and whether it is flooded, AGM or another type. Our guide on how to read a car battery label explains each marking.
- The tray and hold-down. In a compact roadster, space is tight. The replacement must fit the tray and clamp securely.
- Terminal position and type. Cable lengths are often only just long enough, so a battery with terminals on the “wrong” side may not connect safely.
- Engine. The Nissan V6 needs enough cranking power, especially after the car has been sitting for a while.
Send us a clear photo of the current battery and its label, along with the year of the car, and we will confirm an equivalent before we come to you. Our page on battery compatibility explains how equivalents are matched by size standard and rating.
Why low-use cars are hard on batteries
Most Design-1s are driven for enjoyment rather than commuting. That pattern is harder on a battery than daily use:
- Self-discharge. Lead-acid batteries lose charge slowly when idle, and faster in heat.
- Small parasitic draws. Any alarm, tracker, clock or aftermarket accessory takes a little power all the time.
- Short runs. A short drive to a café and back may not fully recharge a battery that has been sitting.
- Deep discharge. If a battery is left flat for long, sulphation can permanently reduce its capacity.
In the UAE, where under-bonnet and garage temperatures stay high for months, batteries commonly last two to three years in ordinary cars, and a weekend car can do worse if it is not kept charged.
Storage tips for a Design-1
A little care goes a long way:
- Use a smart maintenance charger if the car is parked for more than a week or two. Choose one suited to the battery type fitted.
- Park in shade or a covered garage where possible. Lower temperatures slow battery wear.
- Take a proper drive when you use the car, long enough to put back what starting took out.
- Check aftermarket accessories. Trackers and dash cams wired permanently can drain a small battery quickly.
- If storing for summer, consider disconnecting the battery or fitting a battery isolator, as long as it does not upset any security system.
Our article on leaving your car parked for summer has more general advice.
Signs the battery needs attention
The Design-1 is mechanically simple compared with a modern saloon, so the signs are usually straightforward:
- A slow or uneven crank when starting.
- Clicking from the starter with no crank.
- Gauges or lights dimming sharply when you turn the key.
- A battery that will not hold charge for more than a few days.
- Swelling, leaks, or corrosion on the terminals or tray.
Corrosion around the tray is worth taking seriously on a lightweight car, because it can spread to nearby metal parts and wiring.
How we handle a rare car
We treat a Design-1 the same way we would any special car: carefully, and with the battery confirmed in advance.
- We test first. A battery and charging system test tells us whether the battery is worn out or simply flat, and whether the alternator is charging correctly.
- We protect the car. Covers are used around the work area, and tools are kept away from paintwork and exposed parts.
- We fit the battery securely. Correct polarity, tight terminals, a firm hold-down and clean contacts matter on a car that is driven hard.
- We check charging afterwards and take the old battery away for recycling.
We come to you at home, in a building car park or at the office, across Dubai and on our Sharjah and Abu Dhabi pages. Availability is daily, including late evenings. If the car will not start, our car battery jump start service can help confirm whether the battery is the problem.
If your Design-1 has a different setup
Because Jannarelly is a small maker, some cars may have had batteries upgraded or relocated by previous owners or specialists. If the battery in your car does not match what you expect, tell us when you book. We will work from what is fitted, check it is safe and properly secured, and recommend a like-for-like or suitable equivalent.
Jannarelly battery questions
Can I use any small battery in a Jannarelly Design-1?
No. Size, terminal layout, polarity and the hold-down all have to match what the car was built with. We work from the battery currently fitted and its label so the replacement fits the tray and cables properly.
Why does my Design-1 battery go flat between weekend drives?
Even a simple car has small electrical draws, and heat speeds up self-discharge. A car used once a fortnight in summer may not get enough running time to recharge, so a maintenance charger between drives helps.
Does a Jannarelly need battery coding after replacement?
We are not aware of any battery registration requirement on the Design-1, which has a relatively simple electrical system. We still test the charging system after fitting to make sure the new battery is being charged correctly.
Battery replacement for your Jannarelly.
Tell us the model and year, and send a photo of the current battery if you can.
Daily, including late evenings. Out-of-hours requests are answered as technician availability allows.
